Configuring Your PV System: Modules, Inverters, and Trackers
Last updated June 12, 2024
Introduction: Proper configuration of modules, inverters, and trackers is crucial for optimizing the performance of your PV system. This guide will walk you through the process using RatedPower’s platform.
Step-by-Step Instructions:
- Select PV Modules:
- Log in to your RatedPower account and open your project.
- Navigate to the "Design" section and select "Modules."
- Choose the type of PV modules you want to use from the available options.
- Consider factors such as module efficiency, size, and cost.
- Save your selection.
- Configure Inverters:
- Go to the "Inverters" tab within the Design section.
- Select the appropriate inverters based on your system requirements.
- Input the number of modules per string and strings per inverter.
- Adjust settings such as maximum power point tracking (MPPT) ranges and efficiency ratings.
- Save the inverter configuration.
- Set Up Trackers:
- Move to the "Trackers" tab.
- Choose between fixed-tilt or tracking systems (single-axis or dual-axis).
- Configure the tracker settings, including tilt angle, azimuth, and spacing.
- Ensure that the tracker configuration aligns with site-specific conditions and project goals.
- Save the tracker settings.
- Review and Optimize Configuration:
- Review the entire system configuration to ensure compatibility and optimal performance.
- Run preliminary simulations to check for any issues or improvements needed.
- Make necessary adjustments to modules, inverters, or trackers based on simulation results.
- Save the final configuration and proceed to the next design steps.
Was this article helpful?